MfpgaSetRegister

Board	Supported
Host System	No
V4L2	No
Clarity UHD	No
Concord PoE	No
GenTL	No
GevIQ	No
GigE Vision	No
Indio	No
Iris GTX	No
Radient eV-CL	No
Rapixo CL	Yes
Rapixo CoF	Yes
Rapixo CXP	Yes
USB3 Vision	No

Set the contents of one or more FPGA registers.

Syntax

void MfpgaSetRegister(
    AIL_FPGA_CONTEXT FpgaCommandContext,  //in
    AIL_INT64        RegisterSection,     //in
    AIL_INT          Offset,              //in
    AIL_INT          Length,              //in
    void *           ValuePtr,            //out
    AIL_INT64        WriteAccessFlag      //in
)

Description

This function writes values to FPGA registers of the PU associated with the specified command context. A maximum of 16 MfpgaSetRegister calls can be made with any FPGA command context, although you can set the contents of multiple registers in each call. For a PU from the Zebra PU library, you should consult the FDK documentation or relevant examples for details of the register file. You can specify whether write accesses will be collected and made before processing or after the PU finishes processing (according to CompletionMode).

Note: Note that the FPGA module is not supported with Distributed Aurora Imaging Library.

Note: Note that the FPGA module is only supported on boards that support FPGA processing (Pro boards).

Parameters

FpgaCommandContext (in, AIL_FPGA_CONTEXT)

Specifies the handle of the FPGA command context associated with the PU.

RegisterSection (in, AIL_INT64)

Specifies the section of the PU's register space to access. You must set this parameter to the following value:

For register space access

Value	Description
M_PU_BASE	Specifies to access the base address of the PU's register space.

Offset (in, AIL_INT)

Specifies the offset relative to the PU's base address, from which to begin writing, in bytes. The offset must be a multiple of 4 bytes.

Length (in, AIL_INT)

Specifies the number of bytes to write in the register. The length must be a multiple of 4 bytes.

ValuePtr *(out, void)

Specifies the address of the variable in which to write the value to be sent to the register.

WriteAccessFlag (in, AIL_INT64)

Specifies when the register write access must take place. This parameter must be set to one of the following values:

For specifying when to access the register

Value	Description
M_WHEN_COMPLETED	Accesses the registers after the PU issues its end-of-processing interrupt.
M_WHEN_DISPATCHED	Accesses the registers during PU setup, prior to the start of processing.